NAME

ccr — Chelsio T6 crypto accelerator driver

SYNOPSIS

To compile this driver into the kernel, place the following lines in your kernel configuration file:

To load the driver as a module at boot time, place the following line in loader.conf(5):

ccr_load="YES"

DESCRIPTION

The ccr driver provides support for the crypto accelerator engine included on PCI Express Ethernet adapters based on the Chelsio Terminator 6 ASIC (T6). The driver accelerates AES-CBC, AES-CCM, AES-CTR, AES-GCM, AES-XTS, SHA1, SHA2-224, SHA2-256, SHA2-384, SHA2-512, SHA1-HMAC, SHA2-224-HMAC, SHA2-256-HMAC, SHA2-384-HMAC, and SHA2-512-HMAC operations for crypto(4) and ipsec(4). The driver also supports chaining one of AES-CBC, AES-CTR, or AES-XTS with SHA1-HMAC, SHA2-224-HMAC, SHA2-256-HMAC, SHA2-384-HMAC, or SHA2-512-HMAC for encrypt-then-authenticate operations. For further hardware information and questions related to hardware requirements, see http://www.chelsio.com/.

The ccr driver attaches as a child of an existing Chelsio NIC device and thus requires that the cxgbe(4) driver be active.

HARDWARE

The ccr driver supports the crypto accelerator engine included on adapters based on the T6 ASIC:

• Chelsio T6225-CR
• Chelsio T6225-SO-CR
• Chelsio T62100-LP-CR
• Chelsio T62100-SO-CR
• Chelsio T62100-CR

SUPPORT

For general information and support, go to the Chelsio support website at: http://www.chelsio.com/.

If an issue is identified with this driver with a supported adapter, email all the specific information related to the issue to <support@chelsio.com>.

SEE ALSO

crypto(4), cxgbe(4), ipsec(4)

HISTORY

The ccr device driver first appeared in FreeBSD 12.0.

AUTHORS

The ccr driver was written by John Baldwin <jhb@FreeBSD.org>.