| Config::Model::models::LCDd::serialVFD(3pm) | User Contributed Perl Documentation | Config::Model::models::LCDd::serialVFD(3pm) |
Config::Model::models::LCDd::serialVFD - Configuration class LCDd::serialVFD
Configuration classes used by Config::Model
generated from LCDd.conf
Set the initial brightness (4 steps 0-250, 251-500, 501-750, 751-1000) Optional. Type integer.
Device to use in serial mode. Usual values are /dev/ttyS0 and /dev/ttyS1. Optional. Type uniline.
enable ISO 8859 1 compatibility Optional. Type boolean.
Set the initial off-brightness This value is used when the display is normally switched off in case LCDd is inactive (4 steps 0-250, 251-500, 501-750, 751-1000) Optional. Type integer.
Number of Custom-Characters. default is display type dependent Custom-Characters=0 Portaddress where the LPT is. Used in parallel mode only. Usual values are 0x278, 0x378 and 0x3BC. Optional. Type uniline.
Set parallel port timing delay (us). Used in parallel mode only. Optional. Type integer.
Specifies the size of the VFD. Optional. Type uniline.
set the serial port speed Optional. Type enum. choice: '1200', '2400', '9600', '19200', '115200'.
Specifies the displaytype. 0 NEC (FIPC8367 based) VFDs. 1 KD Rev 2.1. 2 Noritake VFDs (*). 3 Futaba VFDs 4 IEE S03601-95B 5 IEE S03601-96-080 (*) 6 Futaba NA202SD08FA (allmost IEE compatible) 7 Samsung 20S207DA4 and 20S207DA6 8 Nixdorf BA6x / VT100 (* most should work, not tested yet.) Optional. Type uniline.
"no" if display connected serial, "yes" if connected parallel. I.e. serial by default. Optional. Type uniline.
| 2023-10-13 | perl v5.36.0 |