tracy-capture(1) tracy-capture User Manual tracy-capture(1)

tracy-capture - A capture application to save traces produced by a tracy client to a file

tracy-capture -o file [-a address] [-p port] [-f] [-s seconds]

The name of the file to write the trace to (required).
Specifies the IP address of the client application (uses localhost if not provided). If no client is running at the given address, the server will wait until it can make a connection.
Network port which should be used (optional).
Force overwrite, if output file already exists.
Number of seconds to capture before automatically disconnecting (optional).

During the capture, the utility will display the following information:

% ./capture -a 127.0.0.1 -o trace
Connecting to 127.0.0.1:8086...
Queue delay: 5 ns
Timer resolution: 3 ns
1.33 Mbps / 40.4% = 3.29 Mbps | Net: 64.42 MB | Mem: 283.03 MB | Time: 10.6 s

The Queue delay and Timer resolution parameters are calibration results of timers used by the client. The following line is a status bar, which displays: network connection speed, connection compression ratio, and the resulting uncompressed data rate; the total amount of data transferred over the network; memory usage of the capture utility; time extent of the captured data.

You can disconnect from the client and save the captured trace by pressing Ctrl + C.

Maintained by Bartosz Taudul <wolf@nereid.pl>. For more information about upstream project, see <https://github.com/wolfpld/tracy/>.

This man page is written for the Debian GNU/Linux system by Alan M Varghese <alan@digistorm.in>.